Kinderkraft KOYA Guide D'utilisation page 36

horizontal slat on the side (9) is facing down. Screw the side to the structure using two screws
(1) (Figure B). Use three screws (1) to connect the side (9) to the second headboard.
3. Place the bottom (11) inside the structure. Note that the mounting holes in the bottom should
be on the underside. Screw the bottom of the baby cot to the previously constructed structure
with four screws (2) (Fig. C). Attention! All four screws (2) should be screwed into the legs (7).
Attention! The bottom of the cot can be adjusted to one of three levels (see point 7).
Attention! The bottom of the cot should be flat - it cannot be tilted.
4. Low side (16) use screw the entire structure to the cot using four screws (1) (fig. E). Remember
that the slat of the low side should face outwards from the cot and form the upper edge of the
low side. Attention! The low side of the cot can be adjusted to one of the three levels (see
point 7).
5. Mounting the wheels: Screw the wheels (6) to the structure (Fig. F) using a spanner (4). The
wheels have a locking device which must be engaged when the cot is set up in the desired place.
To engage the lock, move the lever downwards (fig. I).
6. Make sure that all connections are securely tightened. Slide the mattress into the interior. The
cot ready for connection to the parents' bed is shown in figure S.
7. The low side of the cot is height-adjustable and can be adjusted to the height of the parents
bed. The height of the low side should be adjusted so that its upper edge is at least two
centimetres below the upper surface of the parents' bed (Figure K). To change the position of
the low side, choose one of the three sets of holes which are located on the legs (7) (fig. P) and
then screw the low side into these holes with the screws (1) as described in point 4. Attention!
The bottom of the cot is height-adjustable, but the position of the bottom of the cot has to be
adjusted to the position of the low side. There should be no space between the lower edge of
the low side and the upper edge of the cot bottom (Fig. J). There should be no gaps between
the components and they should not overlap. The relationship between the different positions
is shown in the table below:
To change the position of the bottom (11), select one of the three sets of holes which are
located on the legs (7) (Fig. R - I-III) and then screw the bottom with the screws (2) as indicated
Position of Height from floor
the low side to top edge of low
side
Highest (I) 63,6 cm
Medium (II) 58,8 cm
Lowest (III) 54 cm
in point 3. You can place the cot on its side (9) to adjust the height of the bottom.
8. Use the straps (15) to connect the KOYA cot with the parents' bed. Unfold the strap to its full
length, place it around the lower slat of the low side and the bottom in the outermost space
between the rungs and then attach it to the parents' bed frame or around the parents' mattress
(fig. N + O). Repeat on the other side of the bed. Tension the straps by adjusting their length.
The cot must fit tightly into the parents' bed mattress.
Height from floor to
bottom edge of low
side
53,6 cm
48,8 cm
44 cm
36
Position of Height
the bottom parents'
mattress
Highest (I) Min. 65,6 cm
Medium (II) Min. 60,8 cm
Lowest (III) Min. 56 cm
of the
bed