Kinderkraft KOYA Guide D'utilisation page 37

III Baby cot 90 x 60 cm
For installation you need an Allen key (5) and a spanner (4). Mounting should be
done on a soft surface that will not damage the surface of the components. The
assembly should be carried out by two persons.
1. Screw the two legs (7a + 7b) to the headboard (8). Make sure the holes in
the components are aligned: connect the leg with the headboard where
there are only two holes. Note that there are wheel holes at the ends of the
legs. These leg ends should be at the wider (horizontal) top slat. Connect the headboard to the
legs with four screws (1) (Figure A). Repeat this step with the other legs and the other
headboard.
2. Position one of the sides (9) of the cot perpendicular to one of the structures assembled in step
1. Make sure that the five holes of the side (9) are facing inwards. Make sure that the wider,
horizontal slat of the side (9) is facing down. Screw the side to the structure using two screws
(1) (Figure B). Use three screws (1) to connect the side (9) to the second headboard.
3. Add the second side (9). Make sure that the five holes of the side (9) are pointing inwards. Make
sure that the wider, horizontal slat on the side (9) is facing down. Use five screws (1) to fasten
the side to the structure.
4. Place the bottom (11) inside the structure. Note that the mounting holes in the bottom should
be on the underside. Screw the bottom of the cot to the previously obtained structure using
four screws (2). Attention! All four screws (2) should be screwed into the legs (7). Attention!
The bottom of the cot of the dimensions 90 x 60 cm can be adjusted to one of the four levels
(see point 7).
5. Mounting the wheels: Screw the wheels (6) to the structure (fig. F) using the spanner (4). The
wheels have a locking device which must be engaged when the cot is set up in the desired
position. To engage the lock, move the lever downwards (fig. I).
6. Make sure that all connections are securely tightened. Slide the mattress into the interior. A cot
of the dimensions of 90 x 60 cm that is ready to use is shown in figure T.
7. The bottom of the cot is adjustable in height (11). To change the height of the cot, select one of
the four sets of holes that are located on the legs (7) (Figure R - I-IV), then screw the bottom
with the screws (2) as shown in point 4. You can place the cot on its side (9) to adjust the height
of the bottom.
IV Baby cot 120 x 60 cm
For installation you need an Allen key (5) and a spanner (4). Mounting should be
done on a soft surface that will not damage the surface of the components. The
assembly should be carried out by two persons.
1. Screw the two legs (7a + 7b) to the headboard (8). Make sure the holes in
the components are aligned: connect the leg with the headboard where
there are only two holes. Note that there are wheel holes at the ends of the
legs. These leg ends should be at the wider (horizontal) top slat. Connect the headboard to the
legs with four screws (1) (Figure A). Repeat this step with the other legs and the other
headboard.
37