Kinderkraft KOYA Guide D'utilisation page 35

•
Mattress should have size 120 x 60 cm. Length and width shall be that there shall be
no gap more than 30 mm between the mattress and the sides and ends.
•
All assembly elements and fittings should be tightened properly and checked regularly
and retightened as necessary.
•
To prevent injury from falls, if the child is able to climb out of the cot, the cot shall no
longer be used for that child.
Playpen:
•
WARNING Do not place the playpen close to an open fire or other heat source.
•
WARNING Do not use the playpen without the base.
•
The bottom of the playpen must be mounted at the lowest level (R-V).
•
The playpen is designed for children up to 24 months.
•
Accessories which are not approved by the manufacturer shall not be used.
•
Be aware that items left inside the playpen may be used as a foothold by the child or
create a danger of suffocation or strangulation.
•
All assembly fittings should always be tightened properly.
•
Do not use the playpen if any part is broken, torn or missing and use only spare parts
approved by the manufacturer. The components may only be obtained from the
manufacturer. Do not use components not authorised by the manufacturer.
I List of baby cot components - page 5-8
1 Screw M6*40 (x22)
2 Screw M6*30 (x12)
3 Connector M6*15 (x10)
4 Spanner
5 Allen key (x2)
6 Wheels (x4)
II Co-sleeping baby cot
For installation you need an Allen key (5) and a spanner (4). Mounting should be
done on a soft surface that will not damage the surface of the components. The
assembly should be carried out by two persons.
1. Screw two legs (7a i 7b) to the headboard (8). Make sure that the holes in
the components are aligned: connect the leg with the headboard where
there are only two holes. Also note that there are wheel holes at the ends
of the legs. These leg ends should be at the wider (horizontal) top slat. Connect the headboard
to the legs with four screws (1) (Fig. A). Repeat this step with the other legs and the other
headboard.
2. Position one of the sides (9) of the cot perpendicular to one of the assembled structures in step
1. Make sure that the five holes in the side (9) are facing inwards. Make sure that the wider
7 Leg A (x2) & leg B (x2)
8 Headboard (x2)
9 Side A & side B
10 A & B side extension
11 Bottom
12 Bottom extension
35
13 ./.
14 ./.
15 Straps (x2)
16 Low side
17 Mattress 90 x 60 cm