Maxspect Turbine Duo Mode D'emploi page 12

The Turbine Duo Controller Unit
English English
Switch ON/OFF of the Turbine Duo
Press and hold the ON/FF button over 4s can turn on or off the appliance. While the appliance
is turned off, the pump will stop working, the indicators and OLED screen of the controller will
be shut down. However, if the appliance is connected to an ICV6 (sold spearately), it still can
be activated by the Syna-G App.
Initialize Your Turbine Duo
Before using the appliance, there are some basic setting you need to do for your Turbine Duo.
Clock: Set up the system clock to match with your local time.
Speed: Set up the minimum head flow for the pump of all time. It means the setting of
minimum water flow for all water movement modes will be calculated based on this
value. The adjustable minimum head flow range is between 1% and 90%.
Battery Mode: Set up the working speed of the pump while it is powered by a backup battery.
The product is packed with a power switch adapter which featured with two power
source cables, one end connects to the power supply unit offered by Maxspect, the
other end connects to a DC12v battery (sold separately). When the power from the
PSU is cut, the power source will be switched to the battery automatically.
10
Operating Instructions
ON/OFF, Feed Mode Button
Mode Switch, Setup Button
Power Indicator
Manual Mode Indicator
Automatic Mode Indicator
Setting Indicator
Control Dial
System Clock
Minimum Head Flow
Battery Mode