Technical Data - Hilti GX 120-ME Mode D'emploi

Nails
X‑EGN 24MX
X‑GN 20 MX
en
X‑GN 27 MX
X‑GN 32 MX
X‑GN 39 MX
X‑GPN 37 MX
Other fasteners
Rings and clips for pipes and conduits
Holder for clips and cables
Holder for cable ties
Hanger for threaded rods and wire
Universal plastic washer

4 Technical data

Right of technical changes reserved.
NOTE
The tool is equipped with a transmitter module.
Tool with magazine
Weight
Dimensions (L x W x H)
Nail length
Nail diameter
Magazine capacity
Contact movement
Operating temperature / ambient temperature with
GC 21 gas can
Operating temperature / ambient temperature with
GC 22 gas can
16
Length
24 mm (¹⁵/₁₆")
20 mm (³/₄")
27 mm (1")
32 mm (1 ¹/₄")
39 mm (1 ⁹/₁₆")
37 mm (1¹/₂")
Designation
X‑FB; X‑DFB
X‑BX; X‑EMTC
X‑EMTSC
X‑EKS; X‑EKSC
X‑EKB
X‑ECT
X‑HS
X‑CC
X‑ET
3.8 kg (8.41 lbs)
431 mm X 134 mm X 392 mm (17" x 5 ¼" x 15 ½")
Max. 39 mm (max. 1 ⁹/₁₆")
∅ 3 mm (∅ 0.118 in) / ∅ 2.6 mm (∅ 0.102 in)
40 + 2 nails or 20 + 2 nails
40 mm (1 ⁹/₁₆")
-5...+45°C (23 °F to 113 °F)
-10...+45°C (14°F to 113°F)
In magazine strips of
10
10
10
10
10
10
Sizes
8...40 mm
³/₈"‑1"
¹/₂"‑1"
16...40 mm
Up to 16 cables
M4‑M8
W6 thread
For use on (please
contact Hilti for de-
tailed information)
Hard concrete /
precast concrete /
steel
Concrete / rendered
masonry (1cm / ³/₈")
/ sand-lime block /
concrete block
Concrete / rendered
masonry (1cm / ³/₈")
/ sand-lime block /
concrete block
Concrete / rendered
masonry (1cm / ³/₈")
/ sand-lime block /
concrete block
Concrete / rendered
masonry (1cm / ³/₈")
/ sand-lime block /
concrete block
Sheet steel / thin steel