Eliminating Minor Faults Yourself - Bosch KAD Série Notice De Montage Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Eliminating minor faults yourself

Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Run an appliance self-test (see chapter "Appliance self-test").
Customer service will charge you for advice even if the appliance is still under guarantee!
Fault
Temperature differs greatly
from the set value.
Displays do not illuminate.
Display indicates "E..".
Warning signal sounds and the
temperature display of the freezer
section flashes.
The freezer section is too warm!
Frozen food is at risk!
The light does not work.
Appliance has no refrigeration
capacity.
The light does not work.
The display does not illuminate.
The refrigerating unit is switching
on more frequently and for longer.
Possible cause
Power failure; the fuse has been switched off;
the mains plug has not been inserted properly.
Electronics have detected a fault.
Freezer section door is open.
Ventilation openings are covered up.
Too much food was placed in the freezer at
once.
The light is defective.
Power failure.
The fuse has been switched off.
The mains plug has not been inserted properly. Check whether the mains plug is secure.
Appliance opened frequently.
The ventilation openings are covered up.
Large quantities of fresh food are being frozen. Do not exceed the freezing capacity.
Remedial action
In some cases it is adequate to switch off the appliance
for 5 minutes.
If the temperature is too high wait a few hours and check
whether the temperature has approached the set value.
If the temperature is too low check the temperature again
the next day.
Connect mains plug. Check whether the power is on, check
the fuses.
Call customer service.
To switch off the warning signal, press alarm/lock button. The
display stops flashing.
The warmest temperature reached in the freezer section is
indicated on the temperature display for 10 seconds.
Close the door.
Remove obstructions.
Do not exceed the freezing capacity.
(See chapter "Light".)
Check whether the power is on.
Check the fuse.
Do not open the appliance unnecessarily.
Remove obstructions.
en
57

Publicité

Table des Matières
loading

Table des Matières