Carat T-3510 Mode D'emploi page 36

GB
wrench, slacken the supports for the lower
wheels.
2) Move the lower wheel support in the adjustment
slot until all vertical play is removed (photo 26).
3) Tighten the lower wheel support again.
2 2 6 6
CAUTION !
IN CASE OF LATERAL MOVEMENT ON THE
CARRIAGE, TIGHTEN
SUPPORTS FURTHER (PHOTO 27).
2 2 7 7
ALL THE WHEEL
14. Disposal
When scrapping either the entire machine or parts
of there, the materials used must be disposed of in
accordance with current laws.
Electric motor
Aluminium
Steel
Copper
Polyamide
Steel
Polyamide
Aluminium
Submersible pump
Polyamide
Steel
Aluminium
Copper
Epoxy Resin
The European Directive 2002/96/CE
arranges that in the event of scrapping of
electrical equipment, they must not be
disposed of city solid refusals but collected
separately, in order to optimize the level of recovery
and recycling of the materials and above all in order
to prevent damages to health and environment.
To comply with European Directive 2002/96/CE, all
electrical equipments must be marked with crossed
basket symbol.
The packing of the machine will be disposed of in
accordance with the methods laid down by current
legislation.
For further information concerning disposal of
electrical equipment, please refer to public
administration service.
36
Main casing
AL
AC
CU
PA
AC
PA
AL
PA
AC
AL
CU