Start / Stop Button - Carat T-3510 Mode D'emploi

GB
9. Control panel
CAUTION !
The T-3510 is fitted with a control panel that has the
following buttons:

1) START / STOP BUTTON:

Which is used to start and stop the machine.
2) EXCESS CURRENT TRIP SWITCH:
This trips out in case of excess current and
disconnects the power supply to the machine.
When this switch trips the manual reset button
is pushed outwards. Should this switch trip, wait
a few minutes before resetting it by pushing the
pin in, in the centre of the button.
3) POWER ON LED (RED):
Lit: Power on
Off: Power off
4) MACHINE RUNNING LED (GREEN)
To indicate that the machine is running.
1 1 1 1
10. Making a square cut
T-3510's versatility makes it possible to make
different types of cuts.
CAUTION !
BEFORE STARTING TO CUT MAKE SURE THAT
THE MATERIAL TO BE CUT IS PROPERLY
SUPPORTED AGAINST THE STOP ON THE
WORKING SURFACE.
SQUARE CUT MAX. DEPTH 110 mm
Using the relevant lever, secure the motor head as
shown in photos 12.
1 1 2 2
- Set up the piece to be cut on the working
surface at the required dimension.
- Start the machine and wait until the cooling
water flows out over the cutting disc. Adjust the
flow of water using the water stopcock on the
disc guard.
1 1 3 3
- Proceed to cut moving the working surface
forward as shown in photo 13.
To form a diagonal cut, rest the workpiece against
the set square as shown in the photo 14 and cut.
1 1 4 4
32