Carat T-3510 Mode D'emploi page 28

GB
Technical Data
Power Supply:
Power Rating:
Type of operation allowed:
INTERMITTENT - SERVICE S6 40%
Rotation Speed:
Capacitor:
Amperometric circuit breaker:
Thermal circuit breaker:
IP level:
Working mass:
Tank capacity
(min/max)
RECOMMENDED USE
Water-cooled tool: DIAMOND TIPPED DISC
CONTINUOUS CROWN:
Ceramics, marble, grès, terracotta
LASER / SECTORS:
Concrete, natural stone, granite, abrasive materials
TURBO:
Concrete, natural stone, granite, refractory material
ALWAYS APPLY
INSTRUCTIONS SUPPLIED BY THE TOOL
MANUFACTURER,
APPLICATION.
Max tool diameter:
Tool hole:
Max cutting depth:
90° cut:
45° cut:
Max cut length:
Water circulation pump:
The noise emission of production samples of this
machine was measured in accordance with the ISO
3745-77 standard.
WITHOUT LOAD
Lw 71,4 [dBW(A)] 0,0 [mW(A)]
Lpm 62,7 [dB(A)] 62,7 [dB(C)max 62,7 [dB(A)] 62,7 [dB(C)max]]
230V 50Hz~
2,2 Kw
40% operating under load
60% running freely
2800 min
40 µF
170°C
68 Kg
: 19 / 25 lit.
THE OPERATING
BEFORE EACH
Ø350 mm
Ø25,4 mm
110 mm
80 mm
800 mm
S2 230V 50Hz
UNDER LOAD
71,4 [dBW(A)] 0,0 [mW(A)]
1. Use
CAUTION !
Read the safety chapter carefully before using
this machine.
Each machine is subjected to a series of tests
and carefully checked before leaving our
factory.
Carat Centrale B.V. is constantly striving to
develop their machines and therefore reserves
the right to change such machines. No claims
-1
may therefore be made on the basis of the data
and illustrations contained in this manual.
13A
The masonry saws T-3510 is a technologically
advanced machine that is suitable for cutting
ceramics, marble, granite, bricks, concrete items
and similar materials. It can also be used square to
54
the surface or at 45°
2. Precautions
• The manufacturer accepts no responsibility
where the T-3510 cutter is used with any tools
other than
"RECOMMENDED USE" paragraph.
• The T-3510 is made to operate under the
conditions
OPERATION ALLOWED", in the "TECHNICAL
DATA" paragraph.
• During cutting operations, allow the machine to
rest as indicated.
• T-3510 is not made to operate continually under
a load.
DANGEROUS
THEMSELVES DURING CUTTING.
TO REDUCE THE RISKS ARISING FROM
FRAGMENTATION
APPROPRIATE PROTECTIVE GOGGLES.
CONTINUOUS USE OF THIS MACHINE FOR 8
(EIGHT) HOURS RESULTS IN EXPOSURE TO
NOISE EXCEEDING 85 dB(A). IT IS THEREFORE
NECESSARY TO WEAR EAR MUFFS THAT
FULFIL LEGAL REQUIREMENTS.
28
those specified
indicated under
CAUTION !
SHARDS MAY
OF MATERIALS,
CAUTION !
in the
"TYPE OF
DETACH
USE