Controller
By pressing the buttons on the controller, you can select the following functions:
14
13
CAUTION!
■
Keep children away from the packaging material. There is a danger of suffocation!
Unpack all parts and check the items supplied for completeness (see "Items Supplied");
also check for transport damage. If you fi nd any damage to the components, do not use
them (!), but contact our customer service department.
Use
CAUTION!
■
The driver must not use the device while driving.
■
Make sure that the device is not exposed to extreme temperatures, strong tempera-
ture fl uctuations, direct sunlight or moisture.
■
The massage seat cushion must not be folded up or covered when it is switched on.
■
For the power supply, use only the adapters which are also supplied.
1. Place the massage seat cushion on a chair, for example, and pull the fastening elas-
tic bands over the backrest so that the seat cushion does not slip.
2. Connect the mains cable to the connecting socket on the device and insert the
mains plug of the adapter into an easily accessible plug socket or the car adapter
into the cigarette lighter.
3. Sit down on the massage seat cushion and lean back.
4. Take the controller in your hand and press the PWR button. The AUTO massage
programme will then start. By pressing the buttons on the controller, you can set the
15
8 WÄRME (HEAT) Switch the heat on and off
8
9 INT Set the massage strength. There are 4 intensity le-
vels.
9
10 MODUS (MODE) Switch forward to the next massage
programme. There are a total of 5 massage program-
mes, including AUTO, in which the 4 different types of
10
massage are run through automatically.
11 OBEN (UPPER) / UNTEN (LOWER) / HÜFTE (HIPS) /
BEIN (LEG) Deactivate and reactivate individual mas-
sage zones.
11
12 TIMER Select the duration of the massage. After 15, 30
or 60 minutes, the device switches off automatically.
13 LEDs indicate the activated massage zones.
14 PWR Switch the device on and off. After switch-on, the
AUTO programme is automatically activated for all mas-
12
sage zones.
The activated function is indicated by the respective LEDs.
EN