Help In Case Of Malfunction - AL-KO HT 2000 EasyFlex Mode D'emploi

GB
NOTE
Repair work is only allowed to be carried
out by expert workshops or our service
centres.
■
Do not get the appliance wet or expose it to
moisture.
■
After each use, clean the housing and cutting
blades with a brush or cloth. Do not use wa-
ter and/or aggressive cleaning agents or sol-
vents - risk of corrosion and damage to the
plastic parts.
■
After every use, remove the rechargeable
battery and inspect the appliance for dam-
age.
■
Clean the cutting blade and spray with rust-
proofing oil.
■
Regularly check the cutting blade. Contact an
AL-KO service centre under the following cir-
cumstances:
■
Defective cutting blade
■
Blunt cutting blade
■
Excessive wear
Malfunction
Engine does not run.
Motor keeps cutting out.
Cutting blade becomes hot
when running. Generation of
smoke.
30
Cause
Rechargeable battery is flat.
Rechargeable battery miss-
ing or rechargeable battery
not seated correctly.
Power supply is interrupted.
Motor protection switch has
switched off the motor be-
cause of overload.
■
Appliance faults
■
The On/Off switch is de-
fective.
No oil on the cutting blade.
■
Cutting blade is blunt.
■
Nicks in the cutting
blade.
■
Inspect all bolts for tightness.
■
Inspect the electrical contacts of the appli-
ance for corrosion, clean with a fine wire
brush if necessary and then spray with a con-
tact spray.

9 HELP IN CASE OF MALFUNCTION

CAUTION!
Risk of injury
Sharp-edged and moving appliance
parts can lead to injury.
■
Always wear protective gloves
during maintenance, care and clean-
ing work.
NOTE
If you encounter any malfunctions that
are not listed in this table or that you
cannot rectify yourself, please contact
our customer service.
Remedy
Charge the rechargeable battery.
Insert the rechargeable battery cor-
rectly.
1. Remove the battery.
2. Clean the plug contacts on the ap-
pliance.
Wait until the motor protection switch
releases the motor.
Contact an AL-KO service centre.
1. Switch off the appliance and re-
move the rechargeable battery.
2. Clean and oil the cutting blade.
3. Insert the rechargeable battery
again.
Contact an AL-KO service centre.
Help in case of malfunction
HT 2000