Hamilton Beach Commercial Tango Série Manuel D'utilisation page 6

Operation
Operating the Blender–Model 91350
wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Controls
Two separate switches on the front panel allow you
to control the blender for precise blending
requirements:
• The Timer dial (Model 91350 only) allows you to
select the blend time. Turn the dial clockwise to
the desired setting.
• The On/Off switch will turn the blender on for
continuous operation or off.
Using the blender
Before you use the blender for the first time, wash
the container, cover, and cutter assembly. Refer to
"Cleaning Instructions." Do not put the cutter
assembly in the dishwasher.
To operate the blender, proceed as follows:
1. Place the blender on a clean, dry, level surface,
set the On/Off switch to Off, and turn the timer
dial counterclockwise to the off position.
2. Place cutter in the threaded collar, blades up. Slip
the gasket OVER the blades and onto the base
of the cutter assembly. Screw the completed
cutter assembly onto the container.
3. Plug the blender into an electric outlet.
4. Place the ingredients to be blended into the
container.
6
Operation
wWARNING
Cut Hazard
Always place cover on jar when blending.
Do not put hands, spoons or other utensils
in jar when blending.
Failure to follow these instructions can
result in broken bones, cuts or other injuries.
Timer
Dial
Model 91350
5. Place the container onto the base.
Make sure it rests securely on the base.
6. Place the cover and filler cap on the
container.
7. Select the desired blend time.
8. Move the On/Off switch to the On position.
Release the switch; blending will stop
automatically after the desired time.
9. For manual operation, set the dial to "manual".
Blender will need to be turned on/off manually.
On (I) /
Off (O)
Switch