Practical Advice - Bosch GWX 18V-10 Professional Notice Originale

Material Application
Stone Cutting
The values specified for speed levels are guide values.
The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
Status indications
Battery charge indicator Meaning/cause
(user interface) (25)
Green Battery charged
Yellow Battery almost empty
Red Battery empty
Overload protection indic- Meaning/cause
ator (29)
Yellow Critical temperature has been reached (mo-
tor, electronics, battery)
Red Power tool is overheated and will switch off
Power tool status indicator Meaning/cause
(28)
Green Status OK
Yellow Critical temperature has been reached or bat-
tery is almost empty
Illuminated red Power tool is overheated or battery is empty
Flashing red Kickback shutdown, restart protection or im-
pact shutdown has been triggered
Flashing blue Power tool is connected to a mobile device or
settings are being transferred
Connectivity functions
In conjunction with the Bluetooth® Low Energy Module, the
following connectivity functions are available for the power
tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
Read the corresponding operating instructions for informa-
®
tion about the Bluetooth Low Energy Module.

Practical advice

The power tool with inserted Bluetooth
u
Module is equipped with a radio interface. Local oper-
Bosch Power Tools
Application tool Speed preselection
level
Diamond cutting disc and 3
cutting guide (cutting
stone is permitted only
with a cutting guide)
tool. Accessories running faster than their rated speed
can break and fly apart.
ating restrictions, e.g. in aircraft or hospitals, must be
observed.
Exercise caution when cutting slots in structural walls;
u
see the "Information on structural design" section.
Clamp the workpiece if it is not secure under its own
u
weight.
Do not load the power tool so heavily that it comes to a
u
stop.
If the power tool has been subjected to a heavy load,
u
continue to run it at no-load for several minutes to
cool down the accessory.
Do not use the power tool with a cut-off stand.
u
®
Low Energy
If the power tool becomes electrostatically charged, the
built-in electronics will switch the power tool off. To start
GWX 18V-10 SC
(125 mm)
-1
[min ]
9000
Solution
–
Replace or charge battery soon
Replace or charge battery
Solution
Run the power tool at no load and allow it to
cool down
Leave the power tool to cool down
Solution
–
Run the power tool at no load and allow it to
cool down, or replace or charge the battery
soon
Allow the power tool to cool down, or replace
or charge the battery
Turn the power tool off and on again
–
1 609 92A 5JY | (03.12.2019)
English | 27