Table des Matières
Publicité
GB - Certificate of Conformity
JAMARA e.K. hereby declares that the model‚ „E-Rix 450 Car-
bon Pro, No. 03 1556, No. 03 1557" follows the appropriate and
relevant EEC Directives, in particular those listed below and that
the model has been constructed accordingly.
Please direct any queries that you may have regarding conformi-
ty to our service department at:
Jamara e.K. | Manuel Natterer
Am Lauerbühl 5 | D-88317 Aichstetten
Tel. +49 (0) 7565/9412-0 | Fax +49 (0) 7565/9412-23
www.jamara.com | info@jamara.com
Further information can also be found at:
www.neuershop.jamara.com/Conformity
GB - General Information
Jamara e.K. is not liable for any damage caused to the product
itself or through this, provided this is due to improper operation or
handling errors. The Customer alone bears the full responsibility
for the proper use and handling, including without limitation, the
assembly, the charging process, the use and choice of the ope-
ration area. Please refer to the operating and user instructions, it
contains important information and warnings.
Disposal information
Please care for a environmental correct and legal way
of disposing the batteries and/or accus. Please, only
throw away empty accus into the collect-boxes in your
local shops or commune. (Normally discharge the ac-
cus, when the model stops running)
Box contents
• Chassis made of Carbon
• PC programmable Transmitter 2,4 GHz
• Battery pack
• Brushless motor installed
• Brushless controller installed
• 4 Servos installed
• Gyro
Functions
• Aileron
• Rudder
• Rotary speed
• Roll
• Pitch
Relevant EC Directives:
- (R&TTE) Radio & Telecom Terminal Equipment 1999/5/EC
- (RoHS) Restriction of Hazardous Substances
2011/65/EU, 2002/95/EC
Attention!
In some countries it is a legal requirement to carry third par-
ty indemnity insurance when operating a radio controlled
model. Please ask your local dealer, governing body or your
insurance company for details.
Attention!
Switch the transmitter on first then the model. When you
are finisished first switch off the model then the transmitter.
• Main rotor head made of plastic alu installed
• Rotor blades made of GRP installed
• Alu tail unit installed
• Painted Canopy made of GRP installed
• Accessories
• Instructions
Highlights:
• Paddle bar under rotor head
• Justified and testflown in Germany
• E-Mail support for transmitter
programming
• All important parts made of Alu or
Carbon
• Main frame made of buckling resistant
Carbon
• 3D setting programmed
• 120° swash plate
• Ideal for intermediate users
All parts of this model should be disposed of correctly, in
particular electronic components may be subject to local
restrictions. Your dealer will advise you.
Technical data
Rotor Ø
Length
Height
Weight
Servos
Battery
Motor
No responsibility is taken for the cor-
rectness of this information. Subject to
change without prior notice. Errors and
omissions excepted.
~ 705 mm
~ 645 mm
~ 230 mm
~ 800 g RTF
3 x 9 g | 1 x 24 g
LiPo 11,1 V 2200 mAh
Brushless 380 W
5
Publicité
Table des Matières
