Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
Fig. O
15
16
Cleaning the filters (Fig. K, L, O, P - R)
•
Pull back on the dust canister release button
release and remove the dust canister
vacuum
as shown in Fig. K.
15
•
Use your index finger and thumb to pinch the filter
housing tabs
17
and lift the filter housing
dust canister as shown in Fig. L.
•
Once the filter housing is removed from the dust
canister, use your index finger and thumb to pinch the
filter housing tabs
17
clockwise and remove it from filter housing as shown
in Fig. P.
•
Remove the foam filter
shown in Fig. Q.
•
Shake or lightly brush any loose dust off of the foam
filter
and filter
23
22
•
Rinse out the dust canister
•
Wash the filters with warm soapy water.
•
Ensure the filters are completely dry before refitting the
filters into the filter housing
•
Refit the clean and dry foam filter
housing
.
18
•
Refit the clean and dry filter
18
by aligning the filter locks
of the filter, with the filter housing slots
the sides of the filter housing, and turn the filter clockwise
until it locks firmly into position as shown in Fig. R.
•
Install the filter housing into the dust canister
ensuring the dust canister slots
housing tabs
as shown in Fig. M.
20
•
Install the dust canister onto the vacuum, until it "clicks"
firmly into position.
nOTE: Ensure the dust port
main handle
of the vacuum and the dust canister
2
release button
is facing away from the vacuum
15
as shown in Fig O.
iMPORTAnT: Maximum dust collection will only be
obtained with clean filters and an empty dust canister.
If dust begins to fall back out of the product after it is
switched off, this indicates that the dust canister is full and
requires emptying.
•
Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
6
16
from the
8
18
and rotate the filter
22
23
from the filter housing as
.
8
with warm soapy water.
18
.
into the filter
23
22
into the filter housing
24
, located on the sides
25
, located on
8
align with the filter
19
is placed towards the
21
•
It is very important that the filters are completely dry
and correctly in position before use.
Fig. P
17
to
Fig. Q
from the
counter-
Fig. R
17
Removing and cleaning the rotary brushes
(Fig. S, T, U, V, W)
CAUTION:
moving parts, disconnect the floor brush from the
vacuum before cleaning or servicing.
16
•
To remove the rotary brush
use a coin or straight screwdriver to rotate the lock
on the lock plate
shown in Fig. S.
•
Remove the lock plate
•
Lift the rotary brush up and slide the drive belt
to the side as shown in Fig. T. The rotary brush
now be removed.
nOTE: The end pieces
you to clear the brushes of any hair or other debris that
may have accumulated as shown in Fig. U.
18
23
18
24
25
To reduce the risk of injury from
26
from the floor brush
28
to the unlocked position
.
28
32
are also removable allowing
22
22
18
25
9
27
29
as
31
off
26
can
Publicité
Table des Matières
