Black & Decker HFEK520J Mode D'emploi page 6

3 in 1 cordless vacuum
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Fig. D
11
4
While charging, the charger may get warm, this
is perfectly normal and safe. It is safe to leave the
appliance connected to the charger indefinitely. The
charger automatically reduces power consumption
when charging is complete.

WARNING:
at ambient temperatures below 39 °F (4 °C) or above
104 °F (40 °C). Follow all charging instructions and do
not charge the appliance outside of the temperature
range specified in the instructions.
USE
This vacuum cleaner can be used in one of four ways.
With the extension tube
With the floor brush
With the extension tube
tool
. (Fig. G)
10
With the 2 in 1 Accesssory tool
. (Fig. H)
14
Fig. E
15
Fig. G
4
14
Do not charge the battery
6
and the floor brush
and the vacuum
. (Fig. F)
9
15
and the 2 in 1 Accesssory
6
and the vacuum
10
Fig. F
15
15
Fig. H
Switching ON and OFF (Fig. I)
To switch ON, slide the On/Off switch 
" I " position.
For increased power, slide the On/Off switch 
to the " II " position.
nOTE: The floor brush
attached to the vacuum or extension tube. The LED
worklight
switched ON.
nOTE: The state of charge indicator LEDs
illuminate while the vacuum is ON.
To switch OFF, slide the On/Off switch 
position.
Return the product to the charger immediately after use
so that it will be ready and fully charged for the next
use. Ensure that the product is fully engaged with the
charger plug.
Fig. I
9
. (Fig. E)
State of charge indicator
This appliance include a state of charge indicator
consists of four green and one red LED lights that indicate
the level of charge remaining in the battery. This feature is
only activated when the vacuum is powered on.
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack according to
the following indicators:
The LED battery indicator displays the remaining charge and
warns you when the battery is low. The red LED will flash
continuously when the unit is nearly out of charge. If the red
LED flashes continuously when the switch is turned to the
9
will power on when it is
12
will illuminate whenever the unit is
1
< 10% charged
11–29% charged
30–49% charged
50–74% charged
75–100% charged
15
forward to the
1
1
forward
3
will
to the " O "
3
which

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hfek620j

Table des Matières