Weighing; Resetting The Scale; Cleaning - ADE BE 1803 Mode D'emploi

Weighing

Weighing
WARNING against injuries
− Do not step onto the scale with wet feet or when its surface is damp.
Risk of slipping!
1. Step once with a little force on the weighing surface (tap-on function).
In the illuminated display "0.0", as well as the set measuring unit e.g. "kg", is shown.
2. Position yourself on the scale. Remain standing still and do not hold on to anything.
The measured weight will be displayed shortly thereafter.
A few seconds after you step off the weighing surface, the scale will switch off
automatically.
‚ Weigh yourself with as little clothing on as possible.
‚ Try to weigh yourself always at the same time and under consistent
conditions in order to obtain comparable values.

Resetting the scale

Reset the scale to factory settings if unusual or obviously incorrect values are shown on
the display.
1. Remove the battery from the battery compartment and wait a moment.
2. Re-insert the battery. Pay attention to the correct polarity of the batteries (+/-). The
plus pole (+) must point upwards.
After switching the scale on, you can weigh yourself as usual.

Cleaning

NOTE on material damage
− Do not immerse the scale in water or other liquids.
− Do not under any circumstances use harsh, scraping, or abrasive clean-
ing agents or the like to clean the scale. If you do, the surface could be
scratched.
− Wipe down the scale as needed using a lightly dampened, soft cloth.
− Disinfect the weighing surface from time to time using a suitable disinfecting
agent (available at specialist retailers and pharmacies).
18
Bathroom Scale BE 1803 | BE 1804 | BE 1805