Cleaning; Spare Parts; Wiring Diagram - Wessamat Crusher C 103 Mode D'emploi

User manual – English

4.2 Cleaning

1. Pull out mains plug
2. Take out ice bin and empty it
3. Take out inlet metal sheet
4. Insert ice bin
5. Open filling shaft, wipe out interior with a brush and WESSAMAT-Cleaner.
6. Take out ice bin and remove rests of cleaner
7. Thoroughly wipe out insertion compartment for ice bin with a brush and WESSAMAT-Cleaner.
8. Remove rubber plug of rest water drain
9. Clean inside area and insertion compartment with a brush and clear water (repeat this process 2 or 3 times)
10. Rub off inlet metal sheet with a soft cloth and insert it into the compartment
11. Wipe out ice bin with WESSAMAT-Cleaner and rinse thoroughly with clear water
12. Insert ice bin
13. Put in rubber plug of rest water drain
Attention: As almost all cleaner contain acid, all parts treated with cleaner are to be rinsed thoroughly, in
order to avoid corrosion caused by the acid.
For health reasons it is recommended to remove the first production batch after the cleaning from the ice
bin and not to consume it.

4 Spare Parts

18627 limit switch
18628 limit switch
20669 plexiglas lid
25125 ice container PE
31410 operating capacitor
32313 spiral wheel
32314 gear motor
34107 knob handle for plexiglas lid
42405 crusher shaft VA
43335 outer casing
43440 motor coupling
43443 bearing of the shaft

5 Wiring Diagram

Legend:
S1 = limit switch, filling lid
C1 = operating capacitor 5μF
S2 = limit switch, ice container
M1 = gear motor
User-manual
-Crusher-v.03 07/2021 16