Matrix PG 1100 Notice Originale page 12

any acid splash onto hands or clothing, wash
off immediately with soap solution. Should
any acid splash into your eyes, wash it out
immediately with water (for 15 minutes) and
seek the advice of a doctor.
- Refer to the information and instructions
provided by the vehicle manufacturer relating to
charging the battery.
- Do not charge more than one battery at any
one time.
- Do not short circuit the charger clamps.
- Important. If you smell an acrid odor of gas,
this indicates that there is an acute danger of
explosion. Do not switch off the equipment.
Do not remove the charger clamps. Ventilate
the room immediately. Have the battery
checked by customer service staff.
- Keep the connectors clean and protect them
from corrosion.
- Wear acid-resistant gloves and safety
goggles when connecting and charging the
battery and when topping up the battery
with acid or distilled water.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety
regulations and instructions may result in an
electric shock, fire and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
3. Before Turning On
For safety reasons, at the time of purchase, the
MATRIX current generator is sold without fuel.
12
Ensure that there is enough ventilation.
Make sure the starting cable is properly
connected to the sparking plug.
Make sure the environment can ensure a safe
operation of the device.
Upon turning on, no device should be
connected to the generator.
4. Layout
1. Carry handle
2. Fuel cap
3. Petrol cock
4. Pull cord
5. Choke lever
6. On/Off switch
7. Overload cut-out 230 V~
8. 230 V~ socket-outlets
9. Earth connection
10. 12 V d.c. outlet
11. Overload cut-out 12 V d.c.
5. Starting the MATRIX Current
Generator
Start the generator up: (B1-B3)
Open the fuel tap (3) by turning it to the right
(B3).
Set the On/O switch (6) on the "ON" position.
(B1)
Turn the air lever to the right(5). (B2)
Start the engine by pulling with strength the
starter (4). Repeat if necessary .
After turning on the generator, turn back the air
lever (5) to the starting position.
Wiring the generator: (B1)
Now connect the device that you want to
employ to a 230-V plug socket (8).
Warning The generator is suited only for devices
which work at AC power .
The maximum load should not be above 900 W.