Maintenance And Safety - MCS Master DH 7160 Manuel D'utilisation Et De Maintenance

on, and the humidity display window lights on
to display the previously set humidity. The initial
humidity setting is 60% and 3 seconds later the
humidity display window lights on to display cur-
rent humidity.
► Press humidity up or down key to adjust the
humidity needed. If the set humidity is 3% less
than current humidity, the unit runs; if the set hu-
midity is 3% more than current humidity, the unit
stops running.
► When set humidity is less than 30%, the unit
dehumidifies continuously, and the humidity dis-
play window reads "CO".
CAUTION: The device is provided with the
phase protection. If the phases in the electri-
cal outlet to which the devices are connected
are in the wrong sequence, then the humidity
display will show the ES symbol and the buttons
on the control panel will be deactivated. In such
a case change the phase sequence in the elec-
trical outlet and restart the device. This activity
should be performed by an electrical fitter or a
person who has the relevant licence to perform
work related to electrical systems.
SHUT OFF:
► Press "ON/OFF" when the unit is running, the
unit stops running and all indicators die.
NOTICES:
► When the set humidity is higher than current
humidity, the unit will not run.
► When dehumidifying, the fan motor and com-
pressor must be running at least for 3 minutes,
once the compressor starts on. It is strongly for-
bidden to restart the compressor again within 3
minutes after the shut off.
► When operating in low temperature, the unit
judges the system temperature automatically to
defrost. When defrosting, the defrosting indica-
tor lights on, the compressor runs but fan motor
shuts off automatically.
► When you press the memory key, the control-
ler will record current humidity even if the power
is off. The unit will run under previous mode af-
ter power supplied again.
► The humidity display window shows humidity
from 30% to 90%.
► Keep the unit unplugged if not used for a long
time.
►► 4.

MAINTENANCE AND SAFETY

►
► FIG. 3
Do not use any relay, prolonged wire or adaptor.
Otherwise, it might result in fire, radiation, or an
electric shock.
► FIG. 4
Do not put the unit nearby stove or heater. Oth-
erwise parts of unit might melt down or even
catch fire.
► FIG. 5
Do not use the unit in the direct sunshine, wind
or rain. (only for indoor usage)
► FIG. 6
In case of any other problems (for example smell
of scorch ), please shut off the unit and unplug
it. Otherwise, it might result in fire, electric shock
or other malfunctions.
► FIG. 7
Do not use the unit in places easily affected by
chemicals. Strong chemicals might damage the
unit and cause the leakage.
► FIG. 8
Please unplug the unit when not used for a long
time.
► FIG. 9
When cleaning, shut off and unplug the unit.
Otherwise, it might result in an electric shock.
► FIG. 10
Do not use the device when the ambient tem-
perature is below 0 C.
o
► FIG. 11
Do not repair or disconnect the unit yourself.
Otherwise it might result in fire or an electric
shock.
► FIG. 12
Put the unit stably. If the unit turns over, the wa-
ter will flow out from the tank and damage the
objects nearby. Moreover, because of the dam-
age, it might result in fire or an electric shock
BG
CZ
DE
DK
EE
ES
FI
FR
GB
HR
HU
IT
LT
LV
NL
NO
PL
RO
RU
SE
SI
SK
UA
SE
SI
SK
TR
UA