Accessories/Replacement Items; Maintenance - DeVilbiss Healthcare IntelliPAP Standard Plus cpap Série Guide D'instructions

Supplemental oxygen is sometimes prescribed in addition to CPAP for treatment of Obstructive Sleep Apnea. If your
physician prescribed oxygen for your sleep therapy, you can add the oxygen in one of two ways:
1. Obtain the optional oxygen adapter (part #7353D-601) from your homecare provider and connect it to the air supply
port on the IntelliPAP. Connect one end of the air supply tubing to the open end of the adapter and the other end of the
air supply tubing to the mask.
2. If your mask is equipped with an oxygen port, your physician may request that you apply oxygen directly to your mask.

acceSSOrieS/rePlaceMent iteMS

replacement items
Air-inlet filter (4/pk)
Fine particle filter (4/pk)
Air supply tubing (6')
Air supply plug
Humidifier Chamber
Power items
AC power cord (USA)
AC power cord (UK)
AC power cord (EU)
DeVilbiss Masks (uSa) Recommended for use with IntelliPAP
FlexSet
FlexSet Shallow
FlexSet Gel
FlexSet Gel Shallow
EasyFit Nasal
EasyFit Full Face

Maintenance

DanGer
Electric shock hazard-Do not attempt to open or remove the cabinet; there are no user-serviceable components
inside. If service is required, contact your equipment provider for instructions on obtaining service. Opening or
attempting to service your device will void the warranty.
WarninG
Disconnect supply before servicing.
Pressure Accuracy–The IntelliPAP is designed to provide accurate pressure performance from the factory without
additional calibration. No routine service is required provided the device is used in accordance with the manufacturer's
directions.
NOTE–Some countries require periodic servicing and calibration of this kind of medical device. Contact your equipment
provider for further information.
Standard Air-Inlet Filter–Check the filter every 10 days and clean it if necessary. Replace the filter every 6 months or
sooner if it is damaged. The standard filter is designed to filter particles larger than 3.0 microns in size. The IntelliPAP
MUST have the standard filter in place during operation.
Optional Fine Particle Filter–Check the filter every 10 days and replace it if it is dirty or damaged; otherwise replace the
filter every 30 days. The optional fine particle filter is designed to filter particles as small as 0.3 microns in size.
en - 10
DV51D-602 Heater connection cover
DV51D-603 Oxygen adapter
DV51D-629 Carrying case
DV51D-604 Heated Humidifier
DV5C Chamber Sealing Gasket
DV51D-606 AC power cord (Australia)
DV51D-608 DC power cord
DC battery clamp-on adapter (requires DC Power
DV51D-607
Cord DV51D-619)
9354D Serenity
9354S Serenity Shallow
9354G Serenity Gel
9354GS Serenity Gel Shallow
Available in Silicone (S, M, L, XL) or Gel (S, M, L). Contact your equipment provider
Available in Silicone (S, M, L, XL) or Gel (S, M, L). Contact your equipment provider
DV51D-605
7353D-601
DV51D-610
DV5HH
DV5C-614
DV51D-609
DV51D-619
DV51D-696
9352D
9352S
9352G
9352GS