After Use; Maintenance And Cleaning - Rowenta PRO MASTER Mode D'emploi

AFTER USE

11 • Emptying
12 • Storing

MAINTENANCE AND CLEANING

IMPORTANT Unplug and allow the iron to fully cool down before maintenance and cleaning.
13 • Anti-scale system
Your iron contains an anti-scale cartridge to reduce scale deposits. This considerably prolongs
the operational life of your iron. The anti-scale cartridge is an integral part of the water tank
and does not need to be replaced.
14 • Self Clean function
The Self Clean function flushes dirt and scale particles out of the steam chamber.
IMPORTANT Do not use descaling agents, as these damage the lining of the steam cham-
ber and so may impair the steam function.
TIP Use the Self Clean function approx. every 2 weeks. If the water is very hard, clean
the iron weekly.
15 • Cleaning the iron
When the appliance has cooled down, wipe it down with a damp cloth or sponge, as required.
Remove the dirt from the soleplate with a damp cloth or sponge.
IMPORTANT Do not use sharp or abrasive cleaning agents or objects to clean soleplate
and other parts of the iron. If the appliance has been standing unused for long periods,
use the Self Clean function (see § 14).
Allow the appliance to cool down
before storing the iron standing on its heel .
IMPORTANT Do not wind the cord around the hot soleplate. Never
store your iron placed down on the soleplate.
(prolongs the life of the iron)
Fill the water tank with untreated tap water up to the max mark and heat
the iron to the ••• temperature. Unplug the iron and hold it over a sink
horizontally. Hold the steam control into the Self Clean position : steam
will now begin to build up. After a few seconds water will emerge from the
soleplate, rinsing dirt and scale particles out of the steam chamber.
Move the steam control to
Plug in the iron and allow the iron to heat up again. Wait until the remai-
ning water has evaporated. Unplug from the power outlet and allow the
iron to fully cool down.
When cool, the soleplate can be wiped with a damp cloth.
Unplug the iron, pour away remaining
water and set steam control to
Open and close the steam control se-
veral times to prevent the valve hole
into the steam chamber from scaling or
blocking up.
position after approx. 1 minute.
7
.
* depending on model