Passage Of Cables (All Centris Range); Installation Advice - Simu CENTRIS S Manuel De L'installateur

3.3 - Tube preparation for motors with clamping jaws fixing
& : Power supply and
declutching cables.
& : Motor fixation
3.4 - Installation of motors with clamping jaws fixing (steps 1 to 5)
4

Passage of cables (all Centris range)

To change the position of the release handle, turn
the motor over, leaving the limit switches visible.

Installation advice :

- Remove any burr and sharp edges from the tube to avoid damage to cables.
- Exit the disengagement cable in the motor alignment
- Always make a loop with the power cable to avoid any water entering the motor
- Cables passing through a metal wall must be protected and insulated by a sleeve or duct.
- Tie up the cables to avoid any contact with moving parts.
- Allow sufficient curvature radii (150 mm minimum) in order to prevent any blockage.
- Declutching handle assembly: See instructions sheet delivered with the declutching handle kit.
- Minimum length of the declutching cable sheath in case of shortening: * 4,5 m / ** Unrestricted.
0°
25°
0°
115°
0° 1 2
115°
Ø11 mm
2
1
2
1
3
4
2
0° 3 4
Ø11 mm
5
4
3
4
5
Do not wind
the clutch cable
r = 150 mm min.
r
0°
25°
0°
25°
5
6 mm
24 N.m
±2
3
8 mm
30 N.m
±3
r
4/5
EN