Bluetooth Led; Back Panel Description - Ibiza sound DJM150BT-VHF Manuel D'utilisation

d: VOL-: Use this button to
e: VOL+(28): Use this button to
f: EQ(29):Allow you to select the effect.
Display to MP3's information.
g: LED DISPLAY(30):
20. WIRELESS MIC SIGNAL LED
Lights up when a signal is received from the wireless microphone
21.
BLUETOOTH LED: It displays the Bluetooth operating status. When you turn on the power, the Bluetooth
LED is flashing slowly which means that it is ready to connect to a Bluetooth device. If no connection is found
after 1 minute, le LED goes out and enters into standby mode. If the Bluetooth connection is made with a
player, the light flashes slowly, about 2-3 seconds flicker once. At this point you can use the bluetooth player
playing music can hear the music of the corresponding channel.

BACK PANEL DESCRIPTION

22. Power Switch
Press down the button to turn on this unit. The LED will illuminate when the power is on.
23. AC Connection
This unit comes with a 12V AC adapter. Plug into the 12V AC jack before plugging it into a proper power
source.
24. Master Output
Master output connects to the main amplifier (DJ final mix after crossfader section), accepts RCA jacks。
25. MON Output
To connect your AUX unit. These jacks are RCA types. Which are suitable for connection of a recording
device. Its level is not influenced by the master/channel control.
26. Line Inputs Sockets
These inputs, for ch1-ch2 and accept RCA-plug connectors.
27. VHF Antenna
Extend fully to receive the VHF signal from the wireless microphone
©Copyright LOTRONIC 2016
control level down.
control level UP.
DJM150BT-VHF 5