Eiki LC-NB2 Mode D'emploi page 45

Problem:
Remote Control
Units dose not work.
Wireless Mouse
function does not
work.
The image data in
memory card isn't
displayed.
The image data can't
be written in, read
from the memory
card.
WARNING :
High voltages are used to operate this projector. Do not attempt to open the cabinet.
Check the batteries.
Check the ALL-OFF switch on the Remote Control Unit is set to "ON.".
Make sure anything is blocking between the Remote Receiver and the Remote Control
Units.
Make sure you are not too far from the projector when using the Remote Control Units.
Maximum operating range is 5m.
Check the cable connection between the projector and the computer.
Check the mouse setting on your computer.
Turn the projector before your turn on the computer.
Check the memory card is inserted properly into PC CARD SLOT.
Check SmartMedia or PC Card Adapter is set properly.
Check MCI mode is selected.
Check the image data is recorded in the memory card properly.
Start the projector again.
Check the projector is turned on.
Check "Card access" in VIEW menu is selected.
Check Control Cable for Serial Port (optional) is connected properly.
Check the memory card is inserted properly into PC CARD SLOT.
Check Media Card Imager (supplied) is installed in your computer properly.
Check the setting in Media Card Imager (like Serial Port Setting) is set properly.
Try these Solution
APPENDIX
GB
45