Connecting To The Computer - Eiki LC-NB2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

CONNECTING THE PROJECTOR
To connect with the computer, refer to the figure below.
Used cables for connection
• VGA CABLE
• CONTROL CABLE FOR PS/2 PORT
• CONTROL CABLE FOR SERIAL PORT,or ADB PORT
• MAC ADAPTER
• MONITOR CABLE
• PC AUDIO CABLE (stereo)
These cables are not supplied with this projector.
IBM-compatible computers or Macintosh computers (VGA / SVGA / XGA)
To the Monitor
GB
NOTE :
When connecting the cable, the power cords of both the projector and the external equipment should be disconnected
from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on.
12

CONNECTING TO THE COMPUTER

Desktop type
Monitor
Monitor Output
MAC Adapter
Set the slide
switches following
ON
DIP
the chart on the
1 2 3 4 5 6
next page.
VGA Cable
Monitor Cable
Laptop type
To each terminal of your computer
Serial port
PS/2 port
ADB port
Terminal
Terminal
Terminal
Control Cable for PS/2 Port
Control Cable for Serial Port
Audio Speaker
(stereo)
Audio Amplifier
Audio Output
Audio Input
Audio Cable (stereo)
Control Cable for ADB Port

Publicité

Table des Matières
loading

Table des Matières