Operating Procedures - Shizuoka Seiki VAL6 KBE5S Manuel D'utilisation

3-2. Operating procedures

CAUTION
■ Ignition Procedures
• To make sure the heater is ignited, please do not leave the heater until you confirm that it is burning and otherwise func-
tioning properly.
1
Use the fuel gauge to check if the fuel is
sufficiently filled up in the tank.
2
Turn "ON" the operating switch, and the
operating lamp will light and the heater will
ignite in about 5 seconds.
If ignition fails, try again as follows
Stop the operation completely. Wait for the operating lamp to turn off. After the operating lamp has
turned off, try step 2 above again. DO NOT TRY TO IGNITE THE HEATER MORE THAN THREE
TIMES IN A ROW AS FIRE MAY RESULT.
■ Changing combustion speed (for KBE5L only)
The heater has two-step combustion and it
can be changed by change-over switch.
■ Shut-Down Operation
CAUTION
• Before you disconnect the power plug from the AC outlet, please make sure that the air intake motor is stopped.
• Never disconnect the power plug while the heater is operating, it will cause nozzle to be clogged.
10
• If you detect smoke or a burning smell coming from the heater, turn the heater off im-
mediately to help prevent a fire, contact your dealer and the heater inspected before
further operation.
• More than three consecutive attempts to ignite the heater may cause a fire. If the heater
does not ignite after three consecutive attempts, stop trying and contact your dealer for
an inspection of the heater.
• When using the heater, be careful so that the floor surface (in front of it ) may not get
overheated.
• Do not operate the heater, while fuel tank is dirty and foul, to prevent poor ignition or
improper burning.
Observations
• After the operation is shut down, please make sure that the flame is completely extin-
guished before leaving the heater unattended or moving or storing it.
Observations
Operating Switch "ON"
RUN MISFIRE
ON OFF
RUN MISFIRE
ON OFF HIGH LOW
Change-over switch