Assembly Instruction - Shizuoka Seiki VAL6 KBE5S Manuel D'utilisation

ASSEMBLY INSTRUCTION

ASSEMBLY INSTRUCTION
■ KBE5S
The unit is packaged without having the safety guard and wheel parts assembled.
Prior to assembly, check the heater and supplied parts for possible shipping
damage. If any damage is found, do not proceed further. Immediately notify the
dealer from whom you purchased the heater on how to proceed.
Be sure to assemble the safety guard properly before the unit is used.
Follow the instruction below to assemble the safety guard and wheels parts in the
correct order.
No.2
No.2
Put the main structure on the wheel frame
and fasten them with the screws provided.
Screws which are used for temporary joint
in packing are not needed for assembling.
No.1
No.1
Put the shaft through the shaft plate, then
mount the wheels, washers and cutter-pins.
To help prevent accidents, never use the unit without the safety
guard.
No.3
No.3
The safety guard must be fastened with the
screws provided.
CAUTION
1