Domo DO7047S Mode D'emploi page 26

DO7047S
In between ironing and when you have finished ironing your clothing place the iron in
an upright position resting on its back end.
After ironing remove the plug from the mains socket, pour the remaining water out of
the reservoir and leave the iron to cool off in a vertical position.
Spraying
The spray button can be used at all times, with or without steam ironing, as long as the
water reservoir is filled up. When using the spray button for the first time press it in
repeatedly in order to activate it.
Steam shot
Through means of the steam shot you can remove tough
creases.
Adjust the temperature dial to MAX (fig 3) and wait until
the indicator lamp goes out.
Press on the stem shot button. Wait a few seconds so the
steam penetrates the material before pressing again.
Please Note: Do not use the steam shot more than three times in a row so that the best
quality steam is achieved. Repetitive use of the steam shot function will lower the
iron's heat. For this reason, always pay attention to the temperature indicator lamp
before and after using this function.
Self-clean function
You can easily clean the device yourself by following these steps:
• Set the temperature to the maximum.
• Once the maximum temperature is reached, unplug from the mains.
• Hold the appliance above the sink and keep the self-cleaning button depressed.
A lot of cold water will immediately pass through the the base and remove any
limescale particles.
ERROR MESSAGES AND SOLUTIONS
The iron does not warm up.
The temperature dial must be set to the correct temperature. Adjust the setting to a
higher temperature than MIN.
The iron fails to provide steam
The water reservoir is empty. Adjust the settings on the steam dial to '0' and add
water. Allow the iron enough time to warm up and readjust the temperature dial to the
position marked steam ironing (•••).
The steam generating function is not working
The water reservoir must be filled to a minimum of one quarter. The temperature dial
26
www.domo-elektro.be