How To Use - Panasonic CS-A9PKD Comment Utiliser L'appareil

How to use

ECONAVI
To optimise energy saving
ECONAVI
MODE To select operation mode
AUTO - For your convenience
• Unit selects the operation mode according to
the room temperature.
• Once AUTO mode is selected, the unit will
operate at the standard setting temperature.
Room
Operation mode
temperature
23˚C & above
Below 23˚C
Below 20˚C
• Press for "HI" to +2˚C or
to the standard setting temperature.
HEAT - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
To switch between
POWERFUL/
QUIET
powerful & quiet
POWERFUL QUIET
POWERFUL - To reach temperature quickly
POWERFUL
• This operation will stop automatically after 15
minutes.
QUIET - To enjoy quiet operation
QUIET
• This operation reduces airfl ow noises.
Auto OFF/ON button
6
F568955_YT0912-0.indb 6 F568955_YT0912-0.indb 6
Standard setting
temperature
COOL 25˚C
DRY 22˚C
HEAT 21˚C
for "LO" to -2˚C
NORMAL
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
• To use in AUTO mode, press the button once.
• To use in COOL mode, press and hold the button until 1 beep is heard, then
release.
• Press the button again to turn off.
Human activity
sensor and
indicator
Sunlight sensor
and remote
control receiver
Remote control
display
AUTO
FAN
SPEED
HEAT
COOL
DRY
AIR
SWING
OFF/ON OFF/ON
AUTO
ECONAVI
COMFORT
MODE NANOE-G
TEMP TEMP
POWERFUL/ /
AIR SWING
QUIET FAN SPEED
TIMER TIMER
ON ON SET SET
3 3
1 1 2 2
OFF OFF CANCEL CANCEL
SET CLOCK CLOCK RESET
FAN SPEED
To select fan speed
(Remote control display)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
Indicator
(Green)
POWER
(Orange)
TIMER
(Green)
ECONAVI
(Green)
AUTO COMFORT
(Blue)
NANOE-G
(Orange/
POWERFUL/QUIET
Green)
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Press to restore the
remote control to
default setting.
Not used in normal
operations.
12/17/2012 4:17:02 PM 12/17/2012 4:17:02 PM