Hach MET ONE 3400 Série Manuel D'utilisation De Base page 15

Change the particle count location
There are two methods to change the location for a particle count.
• On the Sample screen, push the location name. Select the new location name and confirm.
• On the Sample screen, push the PLUS button to increment the location, or push the MINUS button
to decrement the location.
See settings during the particle count
Location and group settings can be seen at any time during the particle count cycle.
• On the Sample screen, select the Settings tab on the right side of the screen.
See historical data during the particle count
Historical sample data can be seen at any time during the particle count cycle.
1. On the Sample screen, select the ARROW button.
2. Select the HISTORICAL DATA icon to see the data.
Use the filter scan probe
The filter scan probe function applies to 1 CFM and 50 LPM units only.
1. On the Counter Navigation screen, push SAMPLE.
2. In the Test screen, push the FILTER icon.
3. To start the test, push START FILTER PROBE TEST.
4. To end the test, push STOP FILTER PROBE TEST.
5. Push PRINTER to generate a brief report of the last completed test.
How to use the Print Center
About the Print Center
To avoid damage to the printer, do not operate the printer without paper. If the particle counter must be used
without paper, be sure to set the print mode to "None".
The particle counter has a built-in printer. The Print Center screen is accessible from the:
• Counter Navigation screen
• Historical screen
• System Diagnostics screen
• Test/Report Wizard screen
• Area/Location Setup screen
On the Print Center screen the user can:
• Set automatic print functions
• Print buffer records or count averages
Note: Filtered data is printed from the Historical screen.
Print records manually
The buffer holds 5000 records maximum. The Print Center can print the entire buffer or the average
of count cycles. To print records manually:
N O T I C E
N O T I C E
English 15