Reliable Sensor Velocity V200 Guide D'utilisation page 9

Masquer les pouces Voir aussi pour Sensor Velocity V200:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ATTENTION
Before using your Sensor Velocity V200, remove all the paper or plastic bags,
plastic sheets, cards and possible stickers that may be on the outside or
inside of the appliance that acted as handling protection or sales promotion
material. Remove the soleplate protector before using your V200.
Read these instructions before first using your appliance.
This manual is an integral part of the product. Please safeguard it for
future reference.
Do not plug it in without checking that the voltage of the appliance is the same
as your home mains voltage.
Take care that the cord does not touch the hot parts of the appliance.
Check that the socket outlet has a suitable ground connection.
If you steam iron, please refer to section "STEAM IRONING" on page 12.
To fill your V200 or fill it while ironing, follow the instructions in the "FILLING
WITH WATER" section on page 13, unplugging it and using the beaker
provided.
Do not use your V200 steam function without water in the tank as this may
cause irreparable damage to the system.
The appliance may emit a little smoke and a plastic smell during the first few
minutes of use. This is normal and will disappear quickly.
Do not spray "vertical" steam on a garment hanging in the wardrobe or on a
person. Vertical ironing must be done with the garment on a hanger and away
from other garments, elements or persons.
The V200 should be used on a stable ironing surface.
When you finish ironing, always empty the water from the tank. If you want to
drain it while ironing, always unplug the appliance from the mains first.
Keep the V200 in an upright position during storage, leaning on its heel part,
set on a stable surface.
To disconnect the V200, never pull on the power cord, take out the plug.
If the supply cord is damaged, it must be replaced by the manufacturer,
one service agent authorized or a similarly qualified person in order to avoid
a hazard.
The V200 should not be used if it has been dropped or has a crack or leak in
the water tank. If you observe any of these problems, take the V200 to a one
service authorized.
Please never leave the V200 unattended while it is connected to the supply.
Children must be supervised to ensure they do not play with the appliance.
04

Publicité

Table des Matières
loading

Table des Matières