Reliable Sensor Velocity V200 Guide D'utilisation page 11

• Do not put any type of scale remover solvents or products in the water tank.
Do not use perfumed or ironing water either. These products can damage the
interior of the steam generation system.
• Fill the tank without exceeding the maximum level using the beaker provide (8
and keeping the V200 upright. After the tank is full, close the cap (1).
• Keep the water-fill hole cap (1) closed during operation.
• Check the garment to be ironed to see if it has a label that indicates the
ironing temperature.
• We recommend that you classify garments by their required ironing
temperature and that you begin ironing with the garments that require the
lowest temperature (•MIN).
SILK, WOOL, SYNTHETIC FIBRES: minimum temperature (•MIN)
POLYESTER, medium temperature (••)
COTTON, maximum temperature (•••)
LINEN, maximum temperature (MAX)
• Ironing delicate garments with a temperature higher than necessary is
harmful for the fabric and causes burnt residue to get stuck to the soleplate.
• If you have any doubts about the temperature to use for a given garment,
perform a test on a part which won't be seen, beginning with the lowest
temperature settings.
OPERATION
This appliance has been designed exclusively for ironing clothes. Do not use it for
other purposes.
If the appliance is hot, handle it carefully and do not touch the soleplate.
We recommend that the V200 iron be rested horizontally on an approved, heat
resistant iron pad (optional iRest). Storing an iron vertically is less secure and
increases the risk of the iron falling, but with proper care is acceptable.
1. Extend the cable fully and plug in the iron.
2. Turn the temperature selector from the OFF position to the desired position
(see "TEMPERATURE SELECTION").
3. If you wish, select ironing with steam (see "STEAM SELECTION").
4. Take the V200 by the handle and move the soleplate over the garment to
be pressed.
5. To switch off the V200, turn the temperature selector (3) to the OFF
position again.
06