Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN.qxd
5/12/03
12:00
en
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information. Customer service will charge you for advice, even if the appliance is still
under guarantee!
Fault
Displays do not
illuminate.
Display „
illuminates
(Fig. W W /5).
The interior light
does not function;
the refrigerating unit
is running.
The floor of the
refrigerator
compartment is wet.
26
Page 26
Possible cause
Power failure; the fuse has been
switched off; the mains plug
has not been inserted properly.
Fault – the freezer
"
compartment is too warm!
• Ventilation openings have
been covered.
• Too much food was placed in
the freezer compartment at
once.
• Freezer compartment door is
open.
When the fault has been
eliminated, the warning display
switches off shortly afterwards.
The bulb is defective.
The light switch is sticking
(Fig. O/A).
The condensation drainage
pipe is blocked (Fig. I/B).
Remedial action
Check whether the power is on, the fuse must
be switched on.
Ensure that there is adequate ventilation.
Do not exceed max. freezing capacity.
Close the door.
Change the bulb (Fig. O)
1. Pull out the mains plug or switch off the fuse.
2. Rotate dial (C) on the interior light in an anti-
clockwise direction and remove the cover (B).
3. Change the bulb; replacement bulb,
220–240 V a.c., E14 lampholder, see
defective bulb for wattage.
Check whether it can be moved.
Clean the condensation channel and outlet
(Fig. I/B).
Publicité
Table des Matières
