Replacing The Light Bulb; Cleaning And Maintenance - Dometic CoolFreeze CF-18 Manuel D'utilisation

_CF-18_60.book Seite 43 Donnerstag, 26. Juli 2007 3:18 15
6.11

Replacing the light bulb

Only CF-25, CF-35, CF-40, CF-50, CF-60
➤ Press the switch pin (Fig. 0 2, page 5) downwards so that the
transparent part (Fig. 0 1, page 5) of the lamp can be removed
at the front.
➤ Replace the light bulb.
I
Note
Make sure that the polarity is correct. The side of the light bulb
marked with a plus must be placed at the contact which is connect-
ed to the red cable.
I
Note
The LEDs in the light bulb must be aligned with the transparent part
of the lamp.
➤ Press the transparent part of the lamp back into the housing.
7

Cleaning and maintenance

e
Caution – Danger of electrocution!
Always pull out the mains plug before you clean and service the de-
vice.
a Caution – Danger of damaging the device!
Never clean the device under running water or in dish water.
Do not use abrasive cleaning agents or hard objects during clean-
ing as these can damage the device.
Never use brushes, scouring pads or hard or pointed tools to re-
move ice or to loosen objects which have frozen in place.
➤ Occasionally clean the inside of the device with a damp cloth.
22
Cleaning and maintenance