Installing The Main Unit - Clarion NX501E Mode D'emploi Et Manuel D'installation

5. Installing the Main Unit

This unit is designed for fixed installation in the
dashboard.
1. When installing the main unit in NISSAN vehicles,
use the parts attached to the unit and follow the
instructions in Figure 6.
Mounting Screw Holes (Side View of the Main Unit)
For NISSAN vehicle
Installing the Main Unit in NISSAN Vehicle
Trim ring (*1)
Note:
* 1: Position the face panel with its wide edge at the bottom. Fit the edge into
the groove of the main unit.
Figure 5
Main Unit
Mounting bracket
(1 pair for the left and right sides)
Figure 6
When installing the main unit in TOYOTA vehicles,
use the parts attached to the vehicle and follow the
instructions in Figure 7.
2. Wire as shown in Section 7.
3. Reassemble and secure the unit in the dashboard
and set the face panel and center panel.
For TOYOTA vehicle
6- Spacer (thickness: 1mm)
6- Flat head screws
(M5x8)
(Attached to the main unit)
NX501E/NZ501E 61