ADEO Services A011044 Notice De Montage, D'utilisation Et D'entretien page 280

proceed with operation. The safety lock-off button reduces the risk of accidental starting. To turn the tool
OFF, release the ON/OFF trigger switch.
Operation safety warnings
• Check the product, its power line as well as accessories for damage before each use. Do not use the product if it is
damaged or shows wear.
• Double check that the accessories and attachments are properly fixed.
• Always hold the product on its handle. Keep the handle dry to ensure safe support.
• Ensure that the air vents are always unobstructed and clear. Clean them if necessary with a soft brush. Blocked air
vents may lead to overheating and damage the product.
• Switch the product off immediately if you are disturbed while working by other people entering the working area.
Always let the product come to complete stop before putting it down.
• Do not overwork yourself. Take regular breaks to ensure you can concentrate on the work and have full control over
the product.
• Before switching the product on, check whether it has been assembled correctly and all the moving parts are
running smoothly.
• We recommend slightly dampening surfaces in dusty conditions or using a mister attachment.
• Operate the product only at reasonable hours – not early in the morning or late at night when people might be
disturbed.
• Avoid using the product in bad weather conditions, especially when there is a risk of lightning. Do not operate the
product in poor lighting. The operator requires a clear view of the work area to identify potential hazards.
• Use of hearing protection reduces the ability to hear warnings (shouts or alarms). The operator must pay extra
attention to what is going on in the work area. Do not get distracted, and always concentrate on the task.
• Operating similar tools nearby increases both the risk of hearing injury and the potential for other persons to enter
your work area.
• Keep fi rm footing and balance.
• Do not overreach. Overreaching can result in loss of balance. Always be sure of the footing on slopes.
• Walk, never run. Keep all parts of your body away from any moving part.
• Never run the product without the proper equipment attached.
• Do not modify the product in any way or use parts and accessories that are not recommended by the
manufacturer.
EN
If the product is dropped, suffers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
280