Storage
If the power sweeper will not be used for a period longer
than 30 days, follow the steps below to prepare your
unit for storage.
1. Drain the fuel tank completely. Stored fuel containing
ethanol or MTBE can start to go stale in 30 days. Stale
fuel has high gum content and can clog the carburetor
and restrict fuel flow.
2. Start the engine and allow it to run until it stops. This
ensures that no fuel is left in the carburetor. Run the
engine until it stops. This helps prevent gum depos-
its from forming inside the carburetor and possible
engine damage.
3. While the engine is still warm, drain the oil from the
engine. Refill with fresh oil of the grade recommended
in the maintenece plan.
4. Use clean cloths to clean off the outside of the ma-
chine and to keep the air vents free of obstructions.
m Do not use strong detergents or petroleum based
cleaners when cleaning plastic parts. Chemicals can
damage plastics.
5. Inspect for any loose or damaged parts. Repair or re-
place damaged parts and tighten loose screws, nuts
or bolts.
6. Store your unit on flat ground in a clean, dry building
that has good ventilation.
m Do not store the machine with fuel in a non-venti-
lated area where fuel fumes may reach flame, sparks,
pilot lights or any ignition sources.
20