General Conditions; Conformity - SMT DC280 Série Notice Technique

SMT
from the use of non recommended equipment.
Ensure the installation disassembled is clean, as well as the spare elements: particles in
suspension could catch fire when high pressure oxygen is introduced promptly in the process.
Never attempt to modify the technical characteristics of the regulator (outlet pressure, flow, valve
rating, etc.). These modifications could have a major impact on the operation of the module, and
become hazardous for your safety and that of the patient.
During tests performed after intervention, always open the supply valves slowly: brutal oxygen
pressure may cause risks of fire or explosion.
During tests performed after intervention, always open the supply valves slowly: using helium (He)
ou hydrogen (H

6. GENERAL CONDITIONS

Because of a policy of continuous product improvement, SMT reserves the right to change designs and
materials as well as specifications and product informations without prior notification.
SMT preserves completely the intelectual property of their projects, studies and in general on all
documents forwarded to their customers : it is not permitted to communicate, to execute or to use these
documents in any way without their written authorisation.
This instruction manual is a part of the sales contract and is subject to the general terms of sales.
WARNING
!
The frequency of this check is essentially dependent on the use of the equipment (intensive, normal,
occasional); it must be assessed by the sales manager in agreement with the end user.
In any case, it must not exceed 5 years

7. CONFORMITY

SMT products (supply board, pressure regulator, valves, etc) satisfy to requirement of article 4 §3
of 2014/68/UE directive concerning pressurized equipment (PED).
ATTENTION
!
These equipments integrate pressure relief valve or safety which shall not be « CE » marked,
according to paragraph 2 of annex II.
In other case, pressure relief valves and safety devices shall be « CE » marked.
TECHNICAL MANUAL
REGULATOR
), may cause speed problems.
2
Although these valves are very robust, they need to be regularly checked. This
work requires a certain number of precautions to be taken, and must be carried out
by us.
These equipments shall not be « CE » marked
As defined in article 18.
DC280 et DC380
.
NT 0337
Révision : 2
30/06/2015
Page 22 / 24