Helios KWL 45 BEU Notice De Montage Et D'utilisation page 25

Installation and Operating Instructions
NOTE
NOTE
NOTE
Controller KWL 45 BEU
ò
ù
ä
ë
ö
Configuration via software
Ensure that the KWL 45 BEU controller is connected to the PC/laptop by USB connection cable.
If there is no USB connection to the controller and/or if there is no control voltage at the controller, then only saved con-
figurations can be opened and edited. The uploading or reading out of configurations to or from the controller is not
possible in this case!
1 . Language selection
Select desired language via the dropdown menu (
2 . Information button
The description of the corresponding function is displayed (
3 . Reset operating hours
In order to reset the operating hours (
Only the user-defined operating hours (
4 . Load factory settings from controller
In order to load the factory settings from the controller, click button
Factory settings are marked with index *.
5 . End programme
In order to end the programme, click button
6 . Read from controller
No values will be displayed after the first connection.
In order to read the saved data from the controller, click button
→ The software loads the current configuration of the controller.
7 . Write to controller
The configuration is written to the controller by clicking button
8 . Lock/unlock controller
When the controller is locked, configurations cannot be changed without entering the PIN. Even the configuration mode
on the controller is locked.
In order to lock the controller, click button
In order to unlock the controller, click button
ù
12
ü Å
ò
).
ù
) by clicking the information button
), click the button ä .
13
12 ) can be reset. The total operating hours (
ë
ö
.
ü
.
Å
.
î . Enter a 4-digit PIN and repeat this. Then click "Lock".
î . Enter the 4-digit PIN and click "Unlock".
8
11
13
î
Ø
.
) cannot be reset.
13
.
EN
Æ