Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Assembling the system components
5.1Mounting the baseplate taper on the baseplate
2
1
3
4
5.3 Fitting the water collector holder to the baseplate taper
1
3
2
4
5.5 Changing the chuck
3
4
1
2
6.2 Fastening the unit using the vacuum baseplate
Printed: 07.07.2013 | Doc-Nr: PUB / 5069608 / 000 / 00
1. Baseplate
2. Baseplate taper
3. Mounting screws (4)
4. Wrench (supplied with the
baseplate)
1. Baseplate taper
2. Holder
3. Screw
4. 8 mm AF wrench
1. Drive shaft
2. Chuck
3. 21 mm AF wrench
4. 30 mm AF wrench
I
Quick fastening method
I
No need to drill anchor holes
Caution: Must be secured addition-
nally for wall applications with chain,
rope, brace or support to support a
load of at least 300 kg.
For ceiling application is the use of a
vacuum baseplate not allowed.
The coring system must not
be operated before fastening the
baseplate.
5.2 Fitting the wheel assembly to the baseplate
4
3
2
1
5.4 Fitting the interface adaptor to the motor unit
1
2
4
6. Selecting the method of fastening the drilling rig
6.1Anchor fastening
6.3 Bracing using the guide rail
1. Baseplate
2. Wheel
3. Screw
4. 19 mm AF wrench
1. Motor unit
2. Interface adaptor
3. Clamping bar
4. Screw
5. 6 mm AF wrench
3
5
I
Secure method of fastening for
high coring performance
I
Versatile method
I
Suitable for use on wall, ceiling or
floor
I
Can also be used on uneven and
rough surfaces
Caution: The coring system must
not be operated before the rig has
been rigidly secured in position.
I
Quick fastening method
I
No need to drill anchor holes
I
Very rigid
I
Can be used in addition to anchor
fastening or with the vacuum base-
plate
Caution: The coring system must
not be operated before the rig has
been rigidly secured in position.
5
Publicité
Table des Matières
