Technical Data; Start Of Operation - Kuppersbusch TCA630FB Instructions De Montage Et D'utilisation

Instructions for assembly
Mains cable available in the factory
• The hob has been fitted with a temperature-resistant
connection cable in the factory.
• Connection to the mains is carried out in accordance with the
circuit diagram, unless the connection cable is already fitted
with a plug.
• If the mains cable of this appliance is damaged it will need to
be replaced with a special connection cable. In order to avoid
any risks, this must be carried out by the manufacturer or his
Customer Service.
Electrical connections
* Attention! Special power supply 220 - 240 V 3~ !

Technical data

Hob dimensions
Height/ Width/ Depth . . . . . mm 40 x 600 x 520
Cooking zones
front left . . . . . . . . . . . .Ø cm / kW
back left . . . . . . . . . . . .Ø cm / kW
back right . . . . . . . . . . .Ø cm / kW
front right . . . . . . . . . . .Ø cm / kW
Hob total . . . . . . . . . . . . . . . . kW 6,5
Power supply
Mains voltage. . . . . . . . . . . . . . . . . 380-415V 3N~, 50-60 Hz
Component rated voltage . . . . . . . 220 - 240V

Start of operation

Once the hob has been installed and the power supply has been
provided (mains connected) an automatic test of the controls will
be carried out and information for Customer Service will be
indicated.
Important: No items may be on the touch control sensor keys
when the appliance is being connected!
Briefly wipe over the surface of the hob with a sponge and soapy
water and then dry with a clean cloth.
GB
21 /2,3
14,5/ 1,2
18 / 1,8
14,5/ 1,2
29