Labels & Symbols - Evolution R230RCP Notice Originale

Note: The vibration measurement was made
under standard conditions in accordance with:
EN 62841-1:2015
The declared vibration total value
has been measured in accordance with
a standard test method and may be used for
comparing one tool with another.
The declared vibration total value may
also be used in a preliminary assessment
of exposure.
VIBRATION
WARNING: When using this machine the
operator can be exposed to high levels of
vibration transmitted to the hand and arm.
It is possible that the operator could develop
"Vibration white finger disease" (Raynaud
syndrome). This condition can reduce the
sensitivity of the hand to temperature as well
as producing general numbness. Prolonged or
regular users of this machine should monitor
the condition of their hands and fingers closely.
If any of the symptoms become evident, seek
immediate medical advice.
• The measurement and assessment of human
exposure to hand-transmitted vibration in the
workplace is given in:
BS EN ISO 5349-1:2001 and
BS EN ISO 5349-2:2002
• Many factors can influence the actual
vibration level during operation e.g. the work
surfaces condition and orientation and the
type and condition of the machine being
used. Before each use, such factors should
be assessed, and where possible appropriate
working practices adopted. Managing these
factors can help reduce
the effects of vibration:
Handling
• Handle the machine with care, allowing
the machine to do the work.
• Avoid using excessive physical effort on
any of the machines controls.
• Consider your security and stability, and the
orientation of the machine during use.
Work Surface
• Consider the work surface material;
its condition, density, strength,
rigidity and orientation.
WARNING: The vibration emission during actual
use of the power tool can differ from
the declared total value depending on the ways
in which the tool is used. The need to identify
safety measures and to protect the operator are
www.evolutionpowertools.com
based on an estimation of exposure in the actual
conditions of use (taking account of all parts of
the operating cycle, such as the times the tool is
switched off, when it is running idle, in addition
to trigger time).
LABELS & SYMBOLS
WARNING: Do not operate this machine
if warning and/or instruction labels are missing
or damaged. Contact Evolution
Power Tools for replacement labels.
Note: All or some of the following symbols may
appear in the manual or on the product.
Symbol
V
A
Hz
Min
-1
~
Alternating Current
n o
Wear Safety Goggles
Wear Ear Protection
Wear Dust Protection
Read Instructions
Double Insulation Protection
CSA Certification
Waste Electrical &
Electronic Equipment
4
Description
Volts
Amperes
Hertz
Speed
No Load Speed
CE Certification
Warning