Chicco Soft & Dream Mode D'emploi page 16

Masquer les pouces Voir aussi pour Soft & Dream:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
GB
INSTRUCTIONS FOR USE
COMPONENTS
A. Baby carrier
B. Headrest
C. Arm holes (Parent-facing mode)
D.Upper fastener safety clasp
E. Lower fastener and side adjuster safety clasps
F. Baby carrier adjuster strap
G.Seat
H. Button when using the carrier in horizontal mode
I. Shoulder straps
J. Padded back support
K.Back adjuster system
L. Ergonomic adjuster ring
M. Strap binder
N. Leg protector
O. Fabric hood section
P. Lower safety clasp
IMPORTANT INFORMATION
• IMPORTANT: PLEASE READ THESE INSTRUCTIONS CARE-
FULLY BEFORE USING THE PRODUCT AND RETAIN THEM
FOR FUTURE REFERENCE.
READ THESE INSTRUCTIONS CAREFULLY TO GUARANTEE
YOUR CHILD'S SAFETY AT ALL TIMES.
• WARNING: TO AVOID DANGER OF SUFFOCATION RE-
MOVE THE PLASTIC COVER BEFORE USING THIS ARTI-
CLE. THIS COVER SHALL BE DESTROYED OR KEPT AWAY
FROM BABIES AND CHILDREN.
WARNINGS
• Age group: from birth, from 3.5 Kg. to 9 Kg.
• Only use the baby carrier when standing or walking.
• WARNING: Do not use the baby carrier when practising
sport activities.
WARNING: always put the baby carrier on before placing
your baby inside.
• This carrier must not be used to carry your baby around
whilst lying on his back.
• Check that the straps are positioned and adjusted cor-
rectly and the safety clasps are fastened before using the
baby carrier.
• It is recommended to sit down when removing or placing
your baby inside the carrier.
• When your baby is able to hold his head up and keep his
shoulders upright by himself, at about 4 months of age,
you can then carry him around in front-facing mode.
• When your baby is positioned inside the carrier, check that
the capacity straps are regulated properly; adjust them to
achieve the right tension.
• Do not use the baby carrier for more than one child at
a time.
• Always check that there is sufficient space around the
baby's face to ensure correct air circulation.
• Do not use the baby carrier if any parts are broken, torn
or missing.
• Do not assemble any accessories, spare parts or compo-
nents which are not supplied by the manufacturer.
• WARNING: Your balance can be affected by your move-
ment and that of your baby.
• WARNING: Be careful when you bend over or lean for-
wards; make sure that your arms provide sufficient sup-
port for your baby.
• Remember that when your baby is inside the carrier, he
will react to weather or temperature changes before the
person carrying him.
• WARNING: Never leave your baby unattended in the car-
rier when you are not wearing it.
TIPS FOR CLEANING AND MAINTENANCE
CLEANING
Please refer to the care label for cleaning instructions.
Check that the fabric and stitching are in good condition
each time you wash it.
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
MAINTENANCE
Periodically inspect the baby carrier to check for unstitched,
broken, or missing parts; if this is the case, do not use the
product.
HORIZONTAL MODE
HOW TO WEAR THE BABY CARRIER
WARNING: always put the baby carrier on before placing
your baby inside.
WARNING: when using it in horizontal mode, the fabric
hood section (O) must always be fastened to the carrier as
it guarantees safety for your baby when in this position.
Using the baby carrier in horizontal mode is ideal for babies
up to 3-4 months of age
1. Connect the shoulder straps to the safety clasps (P) loca-
ted under the centre section of the baby carrier
(diag. 1).
2. Use the button (H) on one of the shoulder straps to align
them correctly.
3. Put the baby carrier on, threading both straps over one
arm and your head (diag. 3).
4. Use the adjuster to alter the length of the shoulder straps
(diag. 4).
5. Use the back support (J) as a shoulder strap (diag.5).
HOW TO ACCOMMODATE YOUR BABY
It is recommended to sit down with the baby carrier resting
in your lap, or on a table, when placing your baby inside.
6. Check that the side safety clasps are undone, then ac-
commodate the baby inside so he is facing you; check that
his legs slide through the holes properly. Make sure you al-
ways keep a firm hold of your baby so you are not caught
off-guard if he starts moving around (diag. 6).
7. Fasten both the side opening safety clasps, threading
them under the flap and pulling them firmly downwards
until you hear them click into position (diag. 7).
WARNING: Always double-check that the safety clasps are
fastened properly.
8. Adjust the strap length until you find a safe and comfy
position for your baby. It is also necessary to adjust the
waist area and the leg slots so that the baby carrier is never
too wide or too tight and is suitable for your baby's build
(diag. 8).
9. Assemble the padded section by fastening the safety cla-
sps on each end; regulate the length using the adjusters
fitted on each side of the back support (M)(diag. 9).
WARNING: always check that there is sufficient space
around the baby's face to ensure correct air circulation.
16

Publicité

Table des Matières
loading

Table des Matières