Publicité
Les langues disponibles
Les langues disponibles
Warning
The power must be disconnected before adding the snow oil
Please don't let the snow oil flow into the inside of the equipment to avoid short circuit.
IV. Connection of Power and Wire
The exclusive wire should be used between the connection of the snow machine and power. Please
confirm if the rated voltage and frequency are in accordance with the power supply.
Please contact the agent or professional for replacement if the power cable is damaged. The replaced
power cable must be same size as original.
Caution: The ground wire(Y/G wire) must be earthed during power connection; the installation must be in
accordance with specified standards.
V. Operation
Turn on the cover of oil drum, pour the exclusive snow oil in drum.
Use the standard 3-pins signal cable. Connect well the controller, the master and the slave equipment.
Insert the power cord into the power point in the back panel, press the red power switch of back panel
to "ON", the power indicator of the controller will light this moment.
Press the switch of the controller to "ON", the green work indicator will light and the snow oil will begin
to spray.
Adjust the Potentiometer knob of the controller (clock-wise from small to large), can adjust the oil
volume of the pump, with two states of minimum and maximum
Change the back switch of the back panel to adjust the speed of the air compressor, with two states of
minimum and maximum.
VI. Appendix
The equipment adopt High-pressure air compressor and create a powerful airflow, can spray snow oil in
long distance.
VII. Maintenance
Cleaning and Using Frequency of Product
Please clean your snow machine regularly, this can help to reduce the replacement of parts and
charges by maintenance.
Please let the equipment work with 2-4 liters pure water and clean inside pipeline after working about
40 hours.
Please change to the fresh snow oil after not using it for a long time.
VIII. Trouble-shooting
Problem
The equipment don't spray the snow oil
The sprayed snow oil become small
©Copyright LOTRONIC - 2010
Solution
1. Check if the snow oil is used up or not
2. Check if the nozzle is jammed or not
3. Check if the pump work or not
4. Check if the pcb is damaged or not
1. Check if the nozzle is jammed or not
2. Check if the intensity of pump gets weak
3
Publicité
