1.10.
Using the Seat Function Button
control)
Pressing the Seat Function Button again (3 presses are a complete cycle) puts your wheelchair
back in Drive Mode. Use the joystick to control speed and direction as normal.
1.11.
Using the Joystick
Moving the joystick will drive the electric wheelchair in that direction.
amount of joystick movement will determine the speed that the powerchair will
move in that direction.
Make sure that the joystick is in the neutral (central) position when pressing the
on/off button, otherwise the electronics will be locked. To take this block away
let go the joystick until he goes back in neutral position.
2. System connections
Shark
power module
Two seat functions are available for individual adjustment and are
accessed via the Seat Function Button.
Press the Seat button once to toggle the control unit from Drive
mode to Seat mode. Seat Function 1 will be active as noted by the
amber colored "1" LED.
To adjust Seat Function 1, use the joystick Forward/Reverse.
To access Seat Function 2, either press the Seat Function Button
again or move the joystick right. The amber colored "2" LED will
light. Use the joystick Forward/Reverse to set the Seat Function 2
adjustments. Moving the joystick left/right while in Seat Mode
toggles between Seat Function 1 and Seat Function 2.
Left-hand motor
24 V battery
supply
Right-hand motor
Shark
Control unit
7
Shark Operator control
(only for type 3 operator
Light connections
Actuator
connection
(Shark only)
Battery
charger
hand-held device)
vA - 2011-07
The
Programming
(PC-based or