Timer Operation; Timer Off; Heat Mode - Sharp AY -X08CR Notice D'utilisation

TIMER OPERATION

NOTE:
Before setting the timer, make sure the clock is properly set with the current time.

TIMER OFF

AM
FULL
DISPLAY
POWER
MODE FAN
1h
SWING
SET/C
+
| {
(The heat mode symbol
AY-X08CR/AY-X10CR/AY-X13CR)
{ |
TIPS ABOUT TIMER OFF OPERATION
When the TIMER OFF mode is set, the
temperature setting
adjusted to prevent the room from
becoming excessively hot or too cold
while you sleep. (Auto Sleep function)
COOL/DRY MODE:
• One hour after the time operation begins,
the temperature setting rises 1°C higher
than the original thermostat setting.

HEAT MODE:

(only for models AY-X08CR/
AY-X10CR/AY-X13CR)
• One hour after the timer operation
begins, the temperature setting drops
3°C lower than the original thermostat
setting.
NOTE:
• The Auto Sleep function will not acti-
vate during the FAN ONLY mode.
1
2
3
1
3
2
-
is provided only on models
is automatically
Press the TIMER OFF (
The TIMER OFF indicator will blink; press the
TIME ADVANCE or REVERSE buttons to set
the desired time. (The time can be set in 10-
minute increments.)
Point the remote control at the signal receiver
window on the unit and press the TIMER SET
(SET/C) button.
• The orange TIMER lamp (
light.
• The unit will generate a beep when it re-
ceives the signal.
TO CANCEL TIMER MODE
Press the TIMER CANCEL (SET/C) button.
• The orange TIMER lamp (
will turn off.
• The current clock time will be displayed on
the remote control.
MODE FAN
SWING
SET/C
+
|
NOTE:
{
• If any TIMER ON, TIMER OFF and ONE-
HOUR OFF TIMER are set, the TIMER
CANCEL button cancels all settings.
TO CHANGE TIME SETTING
Cancel the TIMER seting first, then set it
again.
E-12
) button.
) on the unit will
) on the unit
(The heat mode symbol
is provided only on models
AY-X08CR/AY-X10CR/AY-
1h
X13CR)
-
{
|