Safety Information - EINHELL TC-LL 2 Traduction Du Mode D'emploi D'origine

Masquer les pouces Voir aussi pour TC-LL 2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DANGER!
When using the equipment, a number of safety
precautions must be observed to avoid injuries
and damage. Please read the complete operating
instructions and safety information with due care.
Keep these operating instructions in a safe place
so that the information is available at all times. If
you give the equipment to any other person, hand
over these operating instructions and the safety
information as well. We cannot accept any liability
for damage or accidents which arise due to
failure to follow these instructions and the safety
information.

1. Safety information

DANGER!
Read all the safety information and
instructions. Failure to adhere to the safety
information and instructions set out below
may result in electric shock, fi re and/or serious
injury. Keep all the safety information and
instructions in a safe place for future use.
Special information about the laser
Caution: Laser radiation
Do not look into the beam
Laser class II
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
<1.0mW @635nm IEC60825-1:2007
Complies with 21 CFR 1040.10 and 1040.11
except for deviations pursuant to Laser
Notice No.50, dated June 24/2007
Never look directly into the laser path.
Never direct the laser beam at reflecting
surfaces or persons or animals. Even a low
output laser beam can inflict injury on the eye.
Caution: Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiation exposure.
Anl_TC_LL_2_USA_SPK7.indb 7
Anl_TC_LL_2_USA_SPK7.indb 7
EN
Never open the laser module.
It is prohibited to carry out any modifications
to the laser to increase its power.
The manufacturer cannot accept any liability
for damage due to non-observance of the
safety information.
Safety information on the batteries
Use of the batteries
Inserting the batteries when the laser is
switched on can cause accidents.
If the equipment is not used correctly, the
batteries may leak. Avoid contact with the
battery fluid. If you come into contact with
battery fluid, clean the affected body part with
running water. If you get battery fluid in your
eyes, seek immediate medical assistance.
Escaped battery fluid can cause skin irritation
and acid burns.
Never expose the batteries to excess heat
such as sunshine, fire or similar.
Never recharge batteries that are not suitable
for recharging. There is a risk of explosion!
Keep batteries away from children, do not
short circuit batteries or disassemble.
Seek a doctor's advice immediately if a
battery is swallowed.
If necessary, clean the contacts on the
battery and equipment before inserting the
batteries.
Ensure that you insert the batteries the right
way round.
Remove flat batteries immediately from the
equipment. There is an increased risk of
leakage.
Always change all batteries in one go.
Insert only batteries of the same type, do not
use different types of batteries or used and
new batteries together.
Make sure that the equipment is switched off
after use.
Remove the batteries if the equipment is not
used over a longer period.
Keep this safety information in a safe place.
- 7 -
03.04.2019 08:45:09
03.04.2019 08:45:09

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

227010711018

Table des Matières