Technical Data; Safety Information - EINHELL NLW 180 Mode D'emploi

Anleitung NLW 180 SPK1
1. Layout (Fig. 1)
1 Laser unit
2 Suction foot base
3 Base for rough surfaces
4 Precision level base
5 Laser goggles
6 Laser target device

2. Safety information

Achtung
Laserstrahlung
Nicht in den Strahl blicken!
Laserspezifikation nach
EN 60825-1: 1994+A1: 2002+A2: 2001
Laser Klasse 2 JG9-635-5L
P: ≤ 5 mW
Ï: 635 nm
Caution:
Laser radiation.
Do not look into the beam!
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces,
persons or animals. Even a low output laser beam
can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open laser module.
When the tool is not going to be used for an
extended period of time, the batteries should be
removed.
3. Use (Fig. 2a - 2d)
This 180° laser projects a laser line which can be
turned through 180°. It is extremely versatile, being
suitable for small jobs such as hanging up pictures
as well as for major projects such as installing
kitchen cabinets. The laser can be used in your
hand, mounted on the precision level base, or fixed
to smooth surfaces by means of the suction foot
base or to rough surfaces such as walls made of
wood, plasterboard etc.
08.09.2006 8:40 Uhr Seite 9

4. Technical data

Accuracy
Operating temperature
Laser class
Laser wave length
Laser output
Laser power supply
Suction foot power supply
5. Starting up the laser unit (Fig. 3/4)
Inserting and changing batteries (Fig. 3/4)
Important! Always make sure that the laser is
switched off before you insert the batteries!
Open the battery compartment cover (1) as shown in
Fig. 4 and insert the batteries supplied. Check that
the battery terminals are positioned correctly.
Use only alkaline-manganese batteries. Do not mix
batteries from different manufacturers. Use batteries
with the same capacity.
Switching on (Fig. 3): To switch the laser on, press
the On/Off switch (2) once.
Switching off (Fig. 3): To switch the laser off, press
the On/Off switch (2) twice.
Operation (Fig. 3)
The laser projects a line which can be turned in steps
through 180°. Move the setting wheel (3) clockwise
or anticlockwise until the required angle is indicated
on the scale (4). The wheel latches in the positions
0°, ±45° and ±90° as these are the most common
angles.
The laser unit comes with a magnetic base plate for
easy mounting and individual adjustment on the
domed metal plate of the suction foot base, on the
base for rough surfaces or on the precision level
base. Horizontal alignment is facilitated by the two
spirit levels (5).
GB
± 0,6 mm/m
-1-40°C
2
635 nm
≤ 5 mW
2 x 1,5 V (AAA)
2 x 1,5 V (AA)
9