Power Supply; Batteries; Adaptor; Electrode - VOLTCRAFT PHT-600 Mode D'emploi

8. Power Supply

a) Batteries
Stored readings will not be lost when the batteries are replaced or run out. Replace the
batteries when the low battery symbol
• Fully extend the hinged cover and insert a coin into the release slot under the
arrow. Gently twist and pry to open.
Insert a battery then replace the compartment cover (4).
•
The meter will automatically shut down after 10 minutes of no activity to preserve
battery life. Press
b) Adaptor
You can also power the meter by connecting a suitable adaptor (not included) to the 9 V/DC
input (5) jack.

9. Electrode

a) Electrode
• The electrode can be submerged in
The glass membrane (10) should not be left to dry out. It is shipped in a soaker bottle (11)
•
containing electrode storage solution. The probe should be stored in the soaker bottle when
not in use.
Air bubbles occasionally move from the stem (9) into the glass membrane (10). If bubbles
•
appear in the glass membrane area, hold the probe at the top of the stem (9) and shake
downward as done to reset a clinical thermometer.
to turn the meter back on.
liquid up to the BNC connector.
shows.
29